recycled_mind
Member
Dear Automation experts,
I want to use the existing lonworks network which uses AWG#20 Shielded twisted pair for my Profibus system because I find difficulty in setting up a new Profibus cabling. This shielded twisted pair lonworks networks are properly installed in a 1/2 inch metal piping.
My question is can I use this without any issues?
Need your advise on my plans.
Thanks,
APS
I want to use the existing lonworks network which uses AWG#20 Shielded twisted pair for my Profibus system because I find difficulty in setting up a new Profibus cabling. This shielded twisted pair lonworks networks are properly installed in a 1/2 inch metal piping.
My question is can I use this without any issues?
Need your advise on my plans.
Thanks,
APS