Hey there,
I have an issue at the moment trying to setup coms between an S7-300 (313C-2-DP) with CP343-1 to an IndraDrive CS controller.
I thought I had it sorted when I got an error on the IndraDrive for invalid data length. So I adjusted the byte size etc and now I have an Error "E4005 No Command value input from master" It also tells me in the field bus diagnostic that its IDLE:Master in stop mode.
The Cp343-1 is running see attached pic. Then I got a mail from supplier with guide on how to setup on Siemens - I have to browse the ethernet node for the mac address of the Drive and set up that way. When i click on browse i keep getting the error shown in the other pic.
I've tried connecting over every interface on PG/PC but to no avail - I am able to ping the drive and the cp343-1 but still nothing.
Any of you guys have any thoughts?
I have an issue at the moment trying to setup coms between an S7-300 (313C-2-DP) with CP343-1 to an IndraDrive CS controller.
I thought I had it sorted when I got an error on the IndraDrive for invalid data length. So I adjusted the byte size etc and now I have an Error "E4005 No Command value input from master" It also tells me in the field bus diagnostic that its IDLE:Master in stop mode.
The Cp343-1 is running see attached pic. Then I got a mail from supplier with guide on how to setup on Siemens - I have to browse the ethernet node for the mac address of the Drive and set up that way. When i click on browse i keep getting the error shown in the other pic.
I've tried connecting over every interface on PG/PC but to no avail - I am able to ping the drive and the cp343-1 but still nothing.
Any of you guys have any thoughts?