Programming cable for Hakko Touch Screen?

Dear friends!
I have a V606eM20 and two artificial V6-CP cables (both are not Hakko original cables, but connected as above). Unfortunately, when I plug the rj45 into MJ1 port, the green power LED on the bottom of device and also touch-screen of device turn OFF (the device turns off!) Therefore, I can't follow the other instructions to transfer form PC-> or vice-versa. :oops:

Does anybody have an idea? What is wrong for my case?
 

Similar Topics

E
Programming cable option for fx2n
Dear all, I have fx2n plc on my hand but I don't have the programming cable sc-09 and it would not be easy for me to get one. I need the cable...
Replies
3
Views
132
geniusintraining
geniusintraining
S
Schneider plc SR2A201BD programming cable
Hi Please I have zeilo smart relay #SR2A201BD but I don't have it's programming cable. Can I use any general usb/rs232 converter? Or need...
Replies
3
Views
176
Zimmer
Z
S
What's up with the price of powerflex programming cable?
1203-USB I can't find it for sale new so I assume it's no longer made? Used, folks want no less than $1k USD for it missing all the cables and in...
Replies
5
Views
2,081
dmroeder
dmroeder
K
PanelView 300 2711-K3A10L1 Programming cable
Hey Guys I am trying to figure out the correct cable to use to connect from my laptop to this Panelview using panelbuilder32. I was sure I had...
Replies
5
Views
2,048
kennadrin
K
S
pinout for Parker 690+ programming cable?
I need to emergency fabricate a cable to program a Parker 690+ VFD. Part # CM351909 I believe. RJ6 on one end, DB9 on the other. I cannot find the...
Replies
1
Views
2,303
strantor
S
Back
Top Bottom