ebooker
Guest
E
Hello:
I am using a GE Fanuc series 9030, I am trying to get it to accurately read temperature. The analog card is set up, and I do get a reading, after I use the rad_2_deg block, the readings are in the 30000, if I divide this by close to 10000 the value is close to room temp in C, It kind of follows the other temperature tester in the 0 to 100 C range being about 4 to 6 deg off, but onc over 100 the gap widens, then I start to get bogus readings around 200. This is the first program that I have written, so I know I have much to learn, I am just not sure what I am doing wrong
I am using a GE Fanuc series 9030, I am trying to get it to accurately read temperature. The analog card is set up, and I do get a reading, after I use the rad_2_deg block, the readings are in the 30000, if I divide this by close to 10000 the value is close to room temp in C, It kind of follows the other temperature tester in the 0 to 100 C range being about 4 to 6 deg off, but onc over 100 the gap widens, then I start to get bogus readings around 200. This is the first program that I have written, so I know I have much to learn, I am just not sure what I am doing wrong