Hi friends;
Finally communication done. I am very thankful to Sir Steve and Russb which guide me through out the post.
I store the configration, programming logic but when store refrence table the message shown its empty and can not be store.
After go online see the logic which develop as under
%AI0001 input to the INT TO REAL block. Q is store in %R00001.
i see its read 32767. while in analog module configration i set following
ACTIVE CHANNEL=1
4 to 20 mA
Low limit=00000
High limit=+32000
Ref add=%AI0001
Ref ADD= %I0001
A guy say me you should also set the refrence table to get correct values mean hi and low limit.
I am unable to understand the refrence table values how to set?
Is there any example in which i read how to set the values? Then i start to develop the logic.
Regards
Finally communication done. I am very thankful to Sir Steve and Russb which guide me through out the post.
I store the configration, programming logic but when store refrence table the message shown its empty and can not be store.
After go online see the logic which develop as under
%AI0001 input to the INT TO REAL block. Q is store in %R00001.
i see its read 32767. while in analog module configration i set following
ACTIVE CHANNEL=1
4 to 20 mA
Low limit=00000
High limit=+32000
Ref add=%AI0001
Ref ADD= %I0001
A guy say me you should also set the refrence table to get correct values mean hi and low limit.
I am unable to understand the refrence table values how to set?
Is there any example in which i read how to set the values? Then i start to develop the logic.
Regards