Rockwell Online Training - 7 days left for a free course

[Jasondelane]

If you haven't taken advantage of getting 1 free course from Rockwell, you need to do it within the next 7 days. These courses are typically in the thousands of dollars when they're instructor led.

https://rockwellautomationfastpass.training.com/

I just finished CCP143:Studio 5000 Logix Designer Level 3: Project Development without having to do the normal Rockwell prerequisite courses. That's normally a 4 day course with two course prerequisites!

So get in there and brush up on Powerflex Drive programming, or Kinetix, or Industrial Network Architecture (my next course) while it's FREE.

 

[_Dock_]

Thanks for the heads up. If I can find the time I’m going to do one of the kinetix courses. It’s high time I get a little better at servo motion.

 

[Steve Jackson]

If you haven't taken advantage of getting 1 free course from Rockwell, you need to do it within the next 7 days. These courses are typically in the thousands of dollars when they're instructor led.

https://rockwellautomationfastpass.training.com/

I just finished CCP143:Studio 5000 Logix Designer Level 3: Project Development without having to do the normal Rockwell prerequisite courses. That's normally a 4 day course with two course prerequisites!

So get in there and brush up on Powerflex Drive programming, or Kinetix, or Industrial Network Architecture (my next course) while it's FREE.

I see they are asking for an access key. Where can I find that?

 

[kolyur]

I see they are asking for an access key. Where can I find that?

When I filled out the enrollment page with my information, they sent me a confirmation email that had the access code in it.

 

[drforsythe]

FYI: I had delays getting enrolled and access key. My initial signup and access key was blocked by my spam filter. I thought that they did not send them and found them when I checked my spam report.