WrongWay
Member
Greetings,
Long time listener, first time caller....
I am fairly new to this so bear with me.
My problem(s) are with the use of integers to prompt message displays on a PV600, also program flow is problematic.I have tried ADD and MOV instructions to N7 to ensure part assembly is in correct sequence(Pokayoke, or at least close to it.) As I work through the sequence to test the install, when I make a pick bin sensor(light curtain) the input makes correctly and then all hell breaks loose. When the rung is true I want a value to move to N7, well when on rung 005 of the main program is true N7:0 jumps to a value of 2 instead of 1 and the PV600 message display jumps to the ERROR state.
Here's a copy of the program to anyone that has not only read this far, but cares to venture further.
Thank you
Long time listener, first time caller....
I am fairly new to this so bear with me.
My problem(s) are with the use of integers to prompt message displays on a PV600, also program flow is problematic.I have tried ADD and MOV instructions to N7 to ensure part assembly is in correct sequence(Pokayoke, or at least close to it.) As I work through the sequence to test the install, when I make a pick bin sensor(light curtain) the input makes correctly and then all hell breaks loose. When the rung is true I want a value to move to N7, well when on rung 005 of the main program is true N7:0 jumps to a value of 2 instead of 1 and the PV600 message display jumps to the ERROR state.
Here's a copy of the program to anyone that has not only read this far, but cares to venture further.
Thank you