RS232 to RS485 Poor Man

mrtweaver

Member
mrtweaver
Join Date
May 2007
Location
Bloomsburg
Posts
329
It has been quite some time but I do remember that once I had found what they refered to as a poor mans RS232 to RS485 converter. I know it was comprised of some LED's a few resistors and a diode or two. However now i can not seem to locate this schematic.

So I am posting here to see if anyone else knows where this web page is or a similar web page.

Thanks and have a great day.
 

Similar Topics

A
MIL 1553B to RS485/RS232 connectors/converters
i have an device which can support serial (RS485,RS232),CAN protocol . i want to connect it to an existing MIB 1553B bus ,what device will I need...
Replies
0
Views
99
AP000001
A
A
3-pin RS232 to RS485
Hello: I have to connect a RS232 Modbus RTU slave that only has Tx, Rx and GND signals to a Modbus RTU master. However, all RS232 to RS485...
Replies
3
Views
240
AlfredoQuintero
A
M
Swapping Siemens CP 341 rs232 to CP 341 rs485
HI All, does anyone know if you have to change a cp 341 rs232 and use a cp341 rs485, what changes have to be made to get it to...
Replies
0
Views
1,346
maico
M
chud
honeywell ms7820 RS232/RS485 COMMS TO PLC
Hi guys Just wondering if anyone has succesfully read barcode data from these barcode scanners to a plc via rs232 or rs485? If so do you guys have...
Replies
0
Views
1,466
chud
chud
S
RS232 or RS485?
I'm working on an application to have a ControlLogix 5561 communicate with a Telesis TMC420 pin stamp / dot peen controller. The Telesis unit has...
2
Replies
18
Views
9,979
Plastic
P
Back
Top Bottom