dave_gibson
Member
Can anyone help or advise on the following issue I have just had.
Recently I found that I was unable to view any of the PLC / HMI nodes that are set up on the AB network running at work.
I checked all LAN and TCP/IP settings and all was fine. I could even ping the nodes from the command window to prove the connection but was still unable to view the nodes in RSlinx.
I even tried un-installing and re-installing RSLinx but still no joy.
When I thought about it the last think I had done on my laptop was install siemens HMI software WinCC Flexible 2007. I un-installed WinCC 2007. After this RSlinx found the conencted nodes without problem or any other changes being made.
Has anybody any ideas why these 2 softwares appeared to clash and what I need to do to get both running on the same laptop??
Recently I found that I was unable to view any of the PLC / HMI nodes that are set up on the AB network running at work.
I checked all LAN and TCP/IP settings and all was fine. I could even ping the nodes from the command window to prove the connection but was still unable to view the nodes in RSlinx.
I even tried un-installing and re-installing RSLinx but still no joy.
When I thought about it the last think I had done on my laptop was install siemens HMI software WinCC Flexible 2007. I un-installed WinCC 2007. After this RSlinx found the conencted nodes without problem or any other changes being made.
Has anybody any ideas why these 2 softwares appeared to clash and what I need to do to get both running on the same laptop??