Hi I am running a CCW application to control a K300 servo drive. Most of it works with the exception of being able to change the motor direction. I can go into the motor setting and reverse polarity manually which changes direction, but cant seem to figure out how to change that through the program. I believe I am connected to the correct pins on the drive. I am running in indexing mode, not step and direction. Any help would be appreciated.
Set direction on K300 from micro830 PLC in CCW
- Thread starter tonyaL
- Start date
Similar Topics
Hello,
I still do not have equipment in to test.
But the RTAC ladder does not have a timer reset coil.
I wonder if a reset coil on Timer.IN is...
Hi,
i am using DVP-14SS2 PLC, after program written to plc, when power is reset, plc doesn't run. always need to connect to pc for the run mode.
Hi need help why this “failure 5 emergency stop “ appears at every startup in the morning ?
Have to shut off main switch at least 10 times on...
Omron AD081-V1 Analog Input Card
Offset & Gain Adjustment
Entering Adjustment Mode
1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
I was loading a program onto an XE1e2 PLC and it got stuck on these two windows and won't progress. It won't let me connect from the PC to reload...