Hello all,
I have been given a program for a machine that we have. I went up to the machine and compared all the blocks. I took all the ones that did not match and made them so.
Then I wanted to check the hardware config. I try to go online and it tells me it doesn't match, from that point there are 2 options. Use current for diagnoses or upload config to PG. I picked upload, I couldn't see any differences that jumped right out at me. And I couldn't save the online config to my project.
Any ideas???
The few posts I have read all deal with uploading and saving FC's, FB's and so on.
Thanks for any information you can give.
I contacted the builder and they say the copy I have was the origianl
I have been given a program for a machine that we have. I went up to the machine and compared all the blocks. I took all the ones that did not match and made them so.
Then I wanted to check the hardware config. I try to go online and it tells me it doesn't match, from that point there are 2 options. Use current for diagnoses or upload config to PG. I picked upload, I couldn't see any differences that jumped right out at me. And I couldn't save the online config to my project.
Any ideas???
The few posts I have read all deal with uploading and saving FC's, FB's and so on.
Thanks for any information you can give.
I contacted the builder and they say the copy I have was the origianl