Siemens S7 315-2PN/DP from RUN->STOP

What did the the error log say that caused the stop? Still the 2005 and 2006 addresses?

Did you already have a look on the physical network if something was out of place? Review any maintenance or problem happening roughly about 6 months ago that could have changed something causing this?
 

Similar Topics

Hello to all. I'm trying to configure the ModBus connection between 315-2PN/DP and Sentron 3200 pack, but without success .. I can not even...
Replies
2
Views
2,592
Dear Sir, I have faced a problem in SIEMENS PLC CPU 315-2PN/DP,the PLC is not communicating with the SCADA.I have called a service engineer,he...
Replies
2
Views
1,882
Hi I am trying to determine the loss of profibus slaves using the PNIODIAG block from Siemens website. It says the default DB is DB200 that is...
Replies
12
Views
10,386
Dear All, May I know if anybody here has a set-up like this? A siemens CPU315-2DP communicating with Siemens BW500 Belt weigher integrator over...
Replies
4
Views
2,363
Hi all! I am doing communication in two S7-300 PLCs CPU 315-2PN/DP After connecting the Profibus connector to both CPUs, one CPU (Slave) is giving...
Replies
25
Views
13,398
Back
Top Bottom