Sinamics s120 profisafe with TIA V13 and STARTER

[Apache]

Hello,

Does anyone have any experience on configuring S120 with TIA and STARTER.


I have 3 CUs. I have made the configuration at both ends, TIA and STARTER. IP-address, Device name, Profisafe address, telegrams (profisafe telegram 30 and telegram 20) have been set.

The probem is that TIA gives the message "not reachable" with every drive.


Any ideas what is missing?

 

[JRW]

Can you do some screen shots ? Hardware of Tia with slot locations and starter telegrams with slot locations etc

 

[Apache]

At the moment I do not have the project with me , but what I remember is following.

Starter and TIA

1 VECTOR_01 telegrams 20 (normal) and 30 (safe)

2 VECTOR_02 telegrams 20 (normal) and 30 (safe)

3 VECTOR_03 telegrams 20 (normal) and 30 (safe)

4 CU telegram 390


I have to check this next week.
Is there any problem with special character in TIA. For example one CU is named s120-a1. Should there be only letters and numbers.

 

[JRW]

Profinet names can not contain special characters.
I generally do it in steps. I set it up without safety first. I get all the comms working ... Green lights etc. then I set up safety.

 

[Apache]

Okey, thanks

I will try to change those names.