Hey, I need help. Its urgent.
There is a SLC 5/04 processor connected to NET-AIC via PMO2 serial cable. From the AIC it then communicates to PV 550 and the spare RS232 port is used for programming or whatever.
It was working fine till yesterday until there was a fault in the controller.
Currently Fault is flashing red.
DH+ is constant green.
RS-232 flashes green slow.
No other indication.
To sort out I decided to go online with the controller(if that's possible) with RSLinx (RS232 DF1 Devices). I am using the auto-configure feature. But it's not communicating.
I've attached the latest backup's communication screenshot
Any ideas on how to proceed.
There is a SLC 5/04 processor connected to NET-AIC via PMO2 serial cable. From the AIC it then communicates to PV 550 and the spare RS232 port is used for programming or whatever.
It was working fine till yesterday until there was a fault in the controller.
Currently Fault is flashing red.
DH+ is constant green.
RS-232 flashes green slow.
No other indication.
To sort out I decided to go online with the controller(if that's possible) with RSLinx (RS232 DF1 Devices). I am using the auto-configure feature. But it's not communicating.
I've attached the latest backup's communication screenshot
Any ideas on how to proceed.