Hello,
Here is my setup - SLC 5/05 connected to one computer via RS-232 for programming running RSLinx 2.41 & RSLogix500 4.10.01 on NT. SLC also connected via Ethernet to another computer (HMI) running XP & Wonderware InTouch 8.0. I can ping the PLC from the HMI computer. Under the AB_ETH-1 Driver configuration I have station 0 as the SLC IP address & station 1 as the HMI address. The default station 63 is Driver. If I leave this as is I get 2 unrecognized devices with red X's through them in RSWho. If I delete station 63 and place the host name "Driver" under station 2 then I get 2 recognized computers with my IP addresses under Who. What am I doing wrong here?
Also, my cables are good and addresses have been triple checked. Bootp is off. Channel 1 configuration in Logix is good. I am wondering if my setup is correct. I feel like I am close but I am missing something simple. I just want to push the Wonderware button and see that output come on!!! Any help is greatly appreciated.
Here is my setup - SLC 5/05 connected to one computer via RS-232 for programming running RSLinx 2.41 & RSLogix500 4.10.01 on NT. SLC also connected via Ethernet to another computer (HMI) running XP & Wonderware InTouch 8.0. I can ping the PLC from the HMI computer. Under the AB_ETH-1 Driver configuration I have station 0 as the SLC IP address & station 1 as the HMI address. The default station 63 is Driver. If I leave this as is I get 2 unrecognized devices with red X's through them in RSWho. If I delete station 63 and place the host name "Driver" under station 2 then I get 2 recognized computers with my IP addresses under Who. What am I doing wrong here?
Also, my cables are good and addresses have been triple checked. Bootp is off. Channel 1 configuration in Logix is good. I am wondering if my setup is correct. I feel like I am close but I am missing something simple. I just want to push the Wonderware button and see that output come on!!! Any help is greatly appreciated.