Caveman
Member
I'm currently building a Stat Cable Tester for molding, and was wandering if anyone else has done this.
It checks the ground wire.
It checks for pins shorted to ground
It checks for shorted to another pin
It checks for open
It checks for reversed
cables to check are:
6 Pin Mainfold
24 Pin Manifold Thermocouple
32 Pin Tip or Thermocouple
Micrologix 1200 L40-bxb, extra 16 input
and 16 Output.
Panelview 1000 C3
Thanks, Jeff K.
It checks the ground wire.
It checks for pins shorted to ground
It checks for shorted to another pin
It checks for open
It checks for reversed
cables to check are:
6 Pin Mainfold
24 Pin Manifold Thermocouple
32 Pin Tip or Thermocouple
Micrologix 1200 L40-bxb, extra 16 input
and 16 Output.
Panelview 1000 C3
Thanks, Jeff K.