Nhrafan26
Member
Kind of racking my brain here with this one today.
Here's what I want to do:
There is an air cylinder with spring return.
I want to initiate the solenoid to turn on after 4 seconds, the cylinder will extend. I then want to count 2 seconds and release the solenoid.
The cylinder will return to collapsed position.
Then I want to count 10 seconds until this repeats. OR if a sensor has detected a gap for longer than say 5 seconds.
Any example of how I can lay this out? I had some example logic written but deleted it. I will try again tomorrow, just looking for ideas or should I used anything besides TOF / TON / ONS to accomplish this?
RSlogix 500.
Here's what I want to do:
There is an air cylinder with spring return.
I want to initiate the solenoid to turn on after 4 seconds, the cylinder will extend. I then want to count 2 seconds and release the solenoid.
The cylinder will return to collapsed position.
Then I want to count 10 seconds until this repeats. OR if a sensor has detected a gap for longer than say 5 seconds.
Any example of how I can lay this out? I had some example logic written but deleted it. I will try again tomorrow, just looking for ideas or should I used anything besides TOF / TON / ONS to accomplish this?
RSlogix 500.