randy741985
Member
Can Someone tell me the Cable pinout for the RS232 connection on a SLC 5/04 and RS LinX Setup Configuration.
Trouble Communicating with SLC 5/04
- Thread starter randy741985
- Start date
bernie_carlton
Lifetime Supporting Member + Moderator
A minimal null-modem.
Pins
2 ---- 3
3 ---- 2
5 ---- 5
Pins
2 ---- 3
3 ---- 2
5 ---- 5
Mickey
Lifetime Supporting Member
And RSLinx configure See PDF below
randy741985
Member
OP
Thanks, For The PDF Very Informative.
Mickey
Lifetime Supporting Member
Your Welcome.
Similar Topics
Disclaimer: English isn’t my native language, so apologize for any incoming grammatical or spelling mistake.
Hello everyone.
I’m trying to make...
We're setting up feed screws to run on VFD's. I'm getting everything set up on a test bench just to make sure everything can communicate properly...
I am unable to establish communication of GOT with atlas copco controller. Controller supports JBUS protocol and GOT has Modbus.
GOT is...
After the new very nice update to this site I could not log in with my original password, tried to recover my account but did not recieve a email...
Hi everyone.
I have an issue with an Allen Bradley PLC model 1769-L30ER. This PLC had a previous program with a different IP address but when I...