Trying to make a bit or a lamp turn on and off

Greg7683

Member
G
Join Date
Jun 2018
Location
Plainfield IN
Posts
355
Trying to make a bit or a lamp Iv tried both turn on when the robot drops a unit into a bay and turn off when the worker oushes it back out to the robot out of the bay and we should be able to be able to manuly push on the square on the touch screen and close it or open it manually as well I can't seem to get it right.

This is for a weintek hmi to a Mitsubishi plc

And the addressing is confusing some have 0304-A and some have 0304-2 it wont let me use the address when there is a dash or a letter. Addressing is PLC D. 0304-A
 
Last edited:

Similar Topics

B
trying to keep modicon 484 alive a bit longer
We have a old 484 and wanted to add a timer to delay a condiction in a network We have the ldp software but no manuals can anyone tell us where to...
Replies
1
Views
1,792
Sliver
Sliver
A
Trying to get copy of Red Lion G315 HMI program but support upload was not ticked.
Hi All, As a precaution my company has been collecting copies all the HMI and PLC programs. I have recorded copies of most of our sites...
Replies
0
Views
62
Angus_Fergusson
A
J
Studio example, now trying in a Micro 820. There is no Control Data Type in CCW.
Replies
3
Views
166
JamesV
J
W
Trying to Load FactoryTalk View ME Program V_11 to Panel View with FactoryTalk View ME V_13
I can't seem to get the Panel View Plus 7 standard edition to downgrade to V_11, when I check the AB downloads and compatibility websites for this...
Replies
1
Views
143
plvlce
P
Mas01
S7 TIA Portal: Trying to use PLCSIM - Software Licence expiry?
Hi I used to be able to launch PLCsim without any problem. Now it tells me " STEP 7 Professional Licence is required to simulate this PLC"...
2
Replies
15
Views
543
Mas01
Mas01
Back
Top Bottom