bakerboy
Guest
B
good afternoon everyone..
my company recently received a new robotic weld cell.
i have been making alot of improvents to the plc program and now
it is time to update the panelview to reflect those changes.
when i try to upload the file everything goes ok.
but when panelbuilder32 tries to open the file i get the following
error message... unable to load file. not a panelbuilder32 file or file is corrupt or disk space is low.
i have also tried using WINpft file transfer utility which is successful also. i get a copy of the program in .pva format.
but same error message is displayed when i try to open it.
the original programmer had version 3.80 and i have 3.70
could that be the problem?...
it is a panelview 550.
i use my version on all the other panelview's in my factory with no problem.
any suggestions?
thanks mark
my company recently received a new robotic weld cell.
i have been making alot of improvents to the plc program and now
it is time to update the panelview to reflect those changes.
when i try to upload the file everything goes ok.
but when panelbuilder32 tries to open the file i get the following
error message... unable to load file. not a panelbuilder32 file or file is corrupt or disk space is low.
i have also tried using WINpft file transfer utility which is successful also. i get a copy of the program in .pva format.
but same error message is displayed when i try to open it.
the original programmer had version 3.80 and i have 3.70
could that be the problem?...
it is a panelview 550.
i use my version on all the other panelview's in my factory with no problem.
any suggestions?
thanks mark