Hiya, I have a project coming up using a unimotion servo linear actuator with a Schneider PLC (tm251)
Are there any blocks available in the Schneider software to allow a variable distance move (10-150mm) to always complete in the same time?
I would give a distance and time and the accel ramps and velocity are auto calculated?
Or is this something I would need to write instructions for?
Thanks
Will
Are there any blocks available in the Schneider software to allow a variable distance move (10-150mm) to always complete in the same time?
I would give a distance and time and the accel ramps and velocity are auto calculated?
Or is this something I would need to write instructions for?
Thanks
Will