mgvol
Member
I couldn't participate in the poll; my most frequently used programming interface was not listed. High-Point Arms .40 ACP w/laser sight.
What Do You Use To Program PLC's?
- Thread starter CaseyK
- Start date
testsubject
Member
lol!!
MarkTTU
Lifetime Supporting Member
mgvol said:
Well now if we're talking about the non-vendor specific "programming" language mine depends on how frustrated I am...
If I want to get some enjoyment out of it its an open sight Ruger 10-22 (.22LR) with the PLC at about 75 yards...
If I'm really PO'D at that particular PLC then its the Glock 19 (9mm) at about 25 feet
testsubject
Member
ahhh, do it right. Put them all on top of a brick of C-4. That's some good fun!
Similar Topics
I have an old Sentry Palletizer (S/O Number 3007 / Serial Number 1172) that has lost its program as the backup battery died years ago. I can...
Can we use a Simotion D455 ethernet port x127 as a gate, to access S7-1500 plc Tia Portal program ?
In the Simatic manager, we used Netpro to do...
Posted this to Reddit with little success, so I figured I would share it here as well.
Very new to PLCs, but figured I would give it a shot to...
I'm a beginner in the automation field and I've set up an automation system connecting several devices (datalogger, radio, etc.) via Modbus RS485...
Hi All, want to ask.
I have PLC a programme to control the valve. The existing programme is to control valve A (Y22), and I want to change to...