wincc hmi connect to Omrom c200he

ajay34

Member
A
Join Date
May 2010
Location
klang
Posts
249
hello all....

i been working with wincc HMI which connect to Omron PLC ch200he..

i facing a problem that ..i cant connect more than 1 HMI to omron using
protocol as on wincc (rs232) ..only way is to close 1 HMI and Open the other HMI ..

is there any confugation i missed or need to at any device in order make all my 3 HMI is working at Omron PLC same time ..
 

Similar Topics

B
HMI GRAPHICS MISSING_WINCC UNIFIED V18.UPD3
Does anyone happen to know how to install the graphic picture in HMI when I go into blower selection there are no graphics shown not only blower...
Replies
1
Views
72
Jkoso
J
T
SIEMENS HMI (WINCC)
Hello colleagues, On a Siemens Multi panel (MP 377 12") of a machine (S7-300) at a customer's site, some parameters need to be changed that have...
Replies
7
Views
308
Timtje
T
T
WinCC Flexible HMI MP377 Data logging
Hi colleagues.We do data logging system.We want to record three temperatures under a certain condition. We prepared the project as follows. We do...
Replies
1
Views
759
tulip
T
Mas01
Siemens TIA v18: WinCC Basic: HMI displaying PASS/FAIL status...
I’m a bit stuck on HMI (KTP-1200) programming… See the picture attached. The PASS or FAIL box should only appear when the toggle switch is...
Replies
7
Views
1,079
mk42
M
Mas01
Siemens S7/TIA v16: WinCC: trying to display value on HMI.....
Hi I'm trying to display a value on the HMI. In monitor mode on the code, I can see that value, but on the HMI , after downloading, it is...
Replies
10
Views
951
Rob...
R
Back
Top Bottom