mylespetro
Member
I literally was reading your thread and then went back to the main forum and saw this thread
I'm going to keep those in mind for future applications though.
Wireless Connect PLCs to the network
- Thread starter jflick
- Start date
I literally was reading your thread and then went back to the main forum and saw this thread
I'm going to keep those in mind for future applications though.
If you really want to go cheap and you have some know how you can go with a raspberry pi. Here is a github for connecting to a PLC over wireless:
https://github.com/dhunt84971/rpi-plc-gateway
https://github.com/dhunt84971/rpi-plc-gateway
geniusintraining
Lifetime Supporting Member + Moderator
Better yet... https://www.automationdirect.com/ad..._plcs_(stackable_micro_modular)/cpus/c2-03cpu
The Click PLC has built in wireless
Similar Topics
I have a very simple wired network using a L32E processor, panelview plus, HP switch and my laptop. I would like advice on what hardware is needed...
Hello everybody:
I am trying to make wireless connection between HMI (eTOP507) and access point (router). Am thinking to connect wireless USB...
Hello !
I used to have a wireless access point that I could plug into a PLC network and set it with an IP address that fit onto my networks...
Hello Y'all,
I was wondering if there is any standalone solution to replace the ethernet cable to connect to a PLC? like perhaps a "Dongle"...
I know this can be done, but I can't get the router config right.
My goal is to physically connect(using an ethernet cable) a device(PLC, RTU...
