Hi Boys
[FONT="]I may ask you to give me a support of EGCP 2.[/FONT]
I want to use it for stand-by (emergency-op) generators in order that it can syncronize two pieces of them.
[FONT="]Speed control type is GAC 5120 and operated with normal opened (NO) actuator.[/FONT]
[FONT="]The problem is that the synconization hasn’t been accomplished yet. [/FONT]
Further when I (short) close the pinout nr 55 and 65 the rpm is increased. While I close the pinout nr. 54 and 65 the rpm is decreased. So it happens reverse opposite the written instructions in manual.
The wiring is OK (double checked). What would be the problem? Where do I have to search the solution?
Thx for all the future help.
Regards
[FONT="]I may ask you to give me a support of EGCP 2.[/FONT]
I want to use it for stand-by (emergency-op) generators in order that it can syncronize two pieces of them.
[FONT="]Speed control type is GAC 5120 and operated with normal opened (NO) actuator.[/FONT]
[FONT="]The problem is that the synconization hasn’t been accomplished yet. [/FONT]
Further when I (short) close the pinout nr 55 and 65 the rpm is increased. While I close the pinout nr. 54 and 65 the rpm is decreased. So it happens reverse opposite the written instructions in manual.
The wiring is OK (double checked). What would be the problem? Where do I have to search the solution?
Thx for all the future help.
Regards