Bilollipop
Member
Hello,
We're trying to get our PV800 on our network, but RSLinx is unable to detect it.
When I add the IP address to the Ethernet Driver, it shows up as unrecognized:
We do have a firewall and a managed switch, but I've created a policy in the firewall settings to enable port 44818 as per this https://literature.rockwellautomation.com/idc/groups/literature/documents/qr/comm-qr001_-en-e.pdf
The PanelView is currently connected via DHCP to our network, with an Initialized Status and Protocol DF1.
Currently on FW Ver: 6.011 (Boot Code: 5.013) using RS Linx Classic 4.00
Any ideas what I should do? Both my laptop and PanelView are on the same subnet.
We're trying to get our PV800 on our network, but RSLinx is unable to detect it.
When I add the IP address to the Ethernet Driver, it shows up as unrecognized:
We do have a firewall and a managed switch, but I've created a policy in the firewall settings to enable port 44818 as per this https://literature.rockwellautomation.com/idc/groups/literature/documents/qr/comm-qr001_-en-e.pdf
The PanelView is currently connected via DHCP to our network, with an Initialized Status and Protocol DF1.
Currently on FW Ver: 6.011 (Boot Code: 5.013) using RS Linx Classic 4.00
Any ideas what I should do? Both my laptop and PanelView are on the same subnet.