OkiePC
Lifetime Supporting Member
Water plant operator twisted the shaft off of this old 4 position selector switch that is mounted in a panel built as a bypass panel for a Danfoss VFD. I'd like to mail them a new identical switch so they can swap it out, but I need help identifying it in order to source a replacement.
If I cannot get an identical switch and need to substitute, then it would be useful to find a data sheet from this one so I don't have to spend too much time picking apart the wiring from this old panel without drawings to figure out which contacts are in which states in each of the four positions.
I was able to pop the contact blocks off the operator and use pliers to put the switch in the "DRIVE" position so the machinery is fine right now and they would only need to touch it if the VFD dies or something (knock on wood).
Thanks
If I cannot get an identical switch and need to substitute, then it would be useful to find a data sheet from this one so I don't have to spend too much time picking apart the wiring from this old panel without drawings to figure out which contacts are in which states in each of the four positions.
I was able to pop the contact blocks off the operator and use pliers to put the switch in the "DRIVE" position so the machinery is fine right now and they would only need to touch it if the VFD dies or something (knock on wood).
Thanks
Last edited: