jonfarrugia
Member
I'm working on a flying shear application consisting of two kinetix 350 drives. I need to find a way to connect the encoder connected to the coneyor back into the PLC so that I can use it as the master to sync the flying shear to.
Any ideas? I know the best way would be to use the aux feedback channel on a kinetix 6500 system but because we only had two servos on this machine, the 6500 didnt make sense cost wise. Now i'm scratching my head trying to find a way to connect the encoder to the system.
The PLC is an 1769-L33ERM
Any ideas? I know the best way would be to use the aux feedback channel on a kinetix 6500 system but because we only had two servos on this machine, the 6500 didnt make sense cost wise. Now i'm scratching my head trying to find a way to connect the encoder to the system.
The PLC is an 1769-L33ERM