Hello all, new to the community!
I have been experiencing an intermittent servo fault on a Kinetix 5500 connected to a VPL motor. Fault code S45: Feedback Comm Fault (Motor Feedback Data Loss Factory Limit)
The system is comprised of 20 devices including distributed I/O, 5 servos, EIP driven solenoid valve manifolds, etc. in a DLR setup. The factory cable has been uncut, connected, and shielded properly. Oddly enough, I have experienced the same axis fault on 2 identical machines and no faults on any other controllers.
Both the motor and controller have been replaced with no success. Any suggestions?
Thanks in advance!
I have been experiencing an intermittent servo fault on a Kinetix 5500 connected to a VPL motor. Fault code S45: Feedback Comm Fault (Motor Feedback Data Loss Factory Limit)
The system is comprised of 20 devices including distributed I/O, 5 servos, EIP driven solenoid valve manifolds, etc. in a DLR setup. The factory cable has been uncut, connected, and shielded properly. Oddly enough, I have experienced the same axis fault on 2 identical machines and no faults on any other controllers.
Both the motor and controller have been replaced with no success. Any suggestions?
Thanks in advance!