Hi all
I thought I had this working but upon doing a checkup a few months after the machine was commissioned, I found that adjusting the RTC via the HMI results in a controller fault. I am simply copying an integer representing (for example) the minute of the day and sending it to the RTC. See the image I attached.. My understanding was the the Copy Word instruction was the only way to do it. I don't know what to put in as the length..is 1 OK? Again, I could have sworn this was working fine during the program debugging phase . Can anyone comment?
I thought I had this working but upon doing a checkup a few months after the machine was commissioned, I found that adjusting the RTC via the HMI results in a controller fault. I am simply copying an integer representing (for example) the minute of the day and sending it to the RTC. See the image I attached.. My understanding was the the Copy Word instruction was the only way to do it. I don't know what to put in as the length..is 1 OK? Again, I could have sworn this was working fine during the program debugging phase . Can anyone comment?
Last edited: