toddp65
Member
So I'm running a glycol cooled vessel control system with a micrologix 1400 and a PV 800.
On the vessel screen is a numeric entry button to enter your desired setpoint and placed above it is the actual temp readout from the program. When you entered the desired setpoint, say 62 degrees (a window pops up and you enter the number thru the keypad) an hit enter, then 63 appears in the set point box (not 62). Several numbers do this-- the majority are the correct number but several don't. Example: 60-61, 62-63, 63-63, 66-66, 67-66... Not sure what to make of this situation.
Thanks
On the vessel screen is a numeric entry button to enter your desired setpoint and placed above it is the actual temp readout from the program. When you entered the desired setpoint, say 62 degrees (a window pops up and you enter the number thru the keypad) an hit enter, then 63 appears in the set point box (not 62). Several numbers do this-- the majority are the correct number but several don't. Example: 60-61, 62-63, 63-63, 66-66, 67-66... Not sure what to make of this situation.
Thanks