I currently have 3 Quickpanels to look after in addition to numerous panelview and PV+'s. I have ProficyME and imported a project for one of the sites. made changes and uploaded via ethernet. All is good there(I found it similar to the panel views and i like the software). But the other 2 sites are not ethernet quickpanels so I need the programming cable 8pin round. It used to be the HMI-CAB-C49 but that was replaced with the GPW-CB02 I believe? I'm curious if this works with ProficyME software instead of Quick Designer. .. I found a GPW-CB02. at www.plccable.com. just want to make sure I got it figured out before I buy. there is also a CB03 on there but unsure if it will work (it's USB Instead of 9pin on the computer end)