Back again everyone with Red Lion questions. I am trying to setup the remote viewing with a Red Lion to a PLC from my computer, but am unable to get it to work. I have the ethernet add on card in the unit and the PLC plugged into the ethernet port on the RL chassis. The PLC address is 192.168.254.128 so I have the network IP address set to .129 and the network mask and gateways are identical. I also have routing enabled and then on the device setup I have that PLC address in the device identification box.
I thought that is all I needed and then I go to the .129 address from my PC and I could see the remote screens I made but perhaps I am wrong?
Thank you for the help.
I thought that is all I needed and then I go to the .129 address from my PC and I could see the remote screens I made but perhaps I am wrong?
Thank you for the help.