bryonc1213
Member
AB SLC 150 controlling outputs with a sequncer works with an exception
step3-4 are a very simple motor control time is not consistent due to weight empty /loaded so installed a simple magnetic 2 wire prox magnet on bin sensor in top and bottom position
Used simple logic to control the prox in theory
Step 3 turn on output 214 to raise bin until prox 209 is closed
Then when timer expires step 4 lower bin output 211 until prox 210 is closed and stop and continues with step 5-7
The reason I had to add rungs was to try and control movement via the proxes as bin gets hung up and wont make it up or down during the timed sequence just a small dc motor running string on a shaft lots of slippage (toy item)
What happened is since the top position is satisfied the bin starts to lower and then goes back because 214 is on and does a jog
I have tried several variations either the lockup no movement or ends in a loop back to step 3
Attached is the file
I was thinking of doing a latch but then the sequencer 902 just end up in a loop again and trying to put the proxies in a SQI was a stalemate
Any ideas?
step3-4 are a very simple motor control time is not consistent due to weight empty /loaded so installed a simple magnetic 2 wire prox magnet on bin sensor in top and bottom position
Used simple logic to control the prox in theory
Step 3 turn on output 214 to raise bin until prox 209 is closed
Then when timer expires step 4 lower bin output 211 until prox 210 is closed and stop and continues with step 5-7
The reason I had to add rungs was to try and control movement via the proxes as bin gets hung up and wont make it up or down during the timed sequence just a small dc motor running string on a shaft lots of slippage (toy item)
What happened is since the top position is satisfied the bin starts to lower and then goes back because 214 is on and does a jog
I have tried several variations either the lockup no movement or ends in a loop back to step 3
Attached is the file
I was thinking of doing a latch but then the sequencer 902 just end up in a loop again and trying to put the proxies in a SQI was a stalemate
Any ideas?