ar.rehmanarshad
Member
I am using Mitsubishi PLC :FX3g and downloaded the program in it. When I connect Mitsubihi FX2N-4DA expansion module, it lost its communication and gets stuck, just hanged.
Why my PLC goes to not responde when ever i connect Analogue module?
- Thread starter ar.rehmanarshad
- Start date
I have used the FX2-4DA on FX3U but never tried on an FX3g but like goghie says it should work.
See here
See here
Analog Control MELSEC-F series | MITSUBISHI ELECTRIC FA
MELSEC-F series Analog Control
www.mitsubishielectric.com
Similar Topics
my problem is when i lost signal with the PLC all the icons or images in the HMI go invincible, how can i change that ?
Hello everyone!
Having a hot standby with H5724M system , I am randomly getting the following errors on the standby PLC:
Message : HSBY: Switch...
Looks like I'm experiencing a lot of "firsts" this week. Here's another:
Loaded a program into a PVPlus 1000 (F/W 8) and PLC program into a...
Hi,
I have a setup where a fan is being controlled by a VFD (1336 Plus II) which interfaces via a scanport module (1203-FM-1) to the PLC...
Hi all, i made a program and when i am trying to test it on the PLC the RED led is turned on. I dont know what am i doing wrong hopefully somebody...