Currently i have my EB_ETH-1 driver setup with an ip for a gateway logix rack
The gateway rack have multiple ENBT cads and so my linx config looks like this.
gateway_enbt (where i have access to)
backplane
different enbt
+A,Ethernet
lots of IP addressed (that i added under properties, that i can drill down to)
the bolded stuff is repeated many times for all my lines...
when i use the linx backup/restore utility it backs up my basic config but it does not backup all my adresses that i have under all the other enbt cards.
Is there any way to back this up/transfer to different linx?
The gateway rack have multiple ENBT cads and so my linx config looks like this.
gateway_enbt (where i have access to)
backplane
different enbt
+A,Ethernet
lots of IP addressed (that i added under properties, that i can drill down to)
the bolded stuff is repeated many times for all my lines...
when i use the linx backup/restore utility it backs up my basic config but it does not backup all my adresses that i have under all the other enbt cards.
Is there any way to back this up/transfer to different linx?