labingtone
Member
I had install the LM90 Serial Software for GE Fanuc 9030 PLC on Windows 98 O.S. My IBM laptop do not have serial port com, It has USB port only. What i did is to install USB to serial converter, I go to the control panel/Device manager and configure it as com1.
To run this LM90 programmer you must go to DOS PROMPT. When I set up the the software to cummunicate with the PLC a warning message is displayed "CONFIGURED PORT IS NOT AVAILABLE".
I would like to clarify if the DOS environment can not recognize the port I Set up on the windows system. Any information is highly appreciated. thank you
To run this LM90 programmer you must go to DOS PROMPT. When I set up the the software to cummunicate with the PLC a warning message is displayed "CONFIGURED PORT IS NOT AVAILABLE".
I would like to clarify if the DOS environment can not recognize the port I Set up on the windows system. Any information is highly appreciated. thank you