I need help setting up a high-speed counter. 1) Can you use any input terminal for HS input to the counter. 2) I have created a DHSCS block for the counter. I have set OP1 to K100, OP2 to C235, OP3 to M4; is it indeed starting from 0 to 100 and then activating M4? 3) Is the output latched or momentary?
C-H PA10AADR/T HS counter help
- Thread starter Charles1
- Start date
Similar Topics
Hi Guys,
I have a 1769-L24-QBFCB1 that has the OK light flashing on the embedded counter module. The manual states it is a resettable fault, but...
Hey Everyone,
After reading a lot on this forum and elsewhere I see not many are fond of the 1794-VHSC module. I can see to a degree as I was...
Hello Folks,
Has anyone configured a Momentum high speed counter on Unity 13.1.
We need the wiring diagram for Momentum High speed counter and...
Hi all,
I am working with an incremental encoder (ABZ signals, 360 ppr (so 1440 counts per rev)) to replace the existing "manual" encoder wheel I...
Hi y'all
Just a quick question for using Rslogix 5000
I'm using a counter up bit with an analog signal (0-10V). When 10V is measured, counter...
