Christoff84
Lifetime Supporting Member + Moderator
Hey folks,
I'm betting this has been answered a few times but I can't seem to find the answer.
I've setup a control logix gateway (1756-ENBT/A, 1756-DHRIO/C x2) to communicate with my PLC network (All SLC 5/04) over ethernet. The PLC network behind the gateway is DH+ (57.6K).
My problem is that I can not upload/download to my panelview 550s over the ethernet. The models are 2711-K5A5 running firmware 2.xx and connected to the PLC via the serial port setup for DH-485.
I believe the problem is located in RSLinx v2.43, I can pass-thru to see the DH485 (Chan 0) on the PLC but nothing on the other side of it (The Panelview). I've always had to plug directly into the DH+ network to upload/download via a PCMK card.
If anyone knows how to solve this any help would be greatly appreciated.
Chris.
I'm betting this has been answered a few times but I can't seem to find the answer.
I've setup a control logix gateway (1756-ENBT/A, 1756-DHRIO/C x2) to communicate with my PLC network (All SLC 5/04) over ethernet. The PLC network behind the gateway is DH+ (57.6K).
My problem is that I can not upload/download to my panelview 550s over the ethernet. The models are 2711-K5A5 running firmware 2.xx and connected to the PLC via the serial port setup for DH-485.
I believe the problem is located in RSLinx v2.43, I can pass-thru to see the DH485 (Chan 0) on the PLC but nothing on the other side of it (The Panelview). I've always had to plug directly into the DH+ network to upload/download via a PCMK card.
If anyone knows how to solve this any help would be greatly appreciated.
Chris.