shaulapto
Member
Hi,
I need change the IO table of a C200HS PLC composed by a main rack
and one expansion rack.
I tried with CX-programmer and also with Syswin using "create",but these programms don't recognize any board in the expansion rack.
I tried also to configure manually the expansion rack but there is
no posibility to download the new configuration to the PLC.
Any suggestions?
I need change the IO table of a C200HS PLC composed by a main rack
and one expansion rack.
I tried with CX-programmer and also with Syswin using "create",but these programms don't recognize any board in the expansion rack.
I tried also to configure manually the expansion rack but there is
no posibility to download the new configuration to the PLC.
Any suggestions?