Micromaster 440 with profibus changing to Altivar71 over Ethernet

jtashaffer

Member
jtashaffer
Join Date
Aug 2009
Location
KY
Posts
415
I am working on converting from a seimens micromaster 440 communicating by profibus to a Schneider Electric altivar 71 communicating over Ethernet. I was wondering if anyone has done this conversion? The seimens vfd had a auto status indicator. I need to do the same for the altivar VFD. I am using LI3 as my logic switch for auto. It is a hand/off/auto setup. Does anyone know what the scanner input address would be for LI3 when it is switched on.
 

Similar Topics

M
PROFIBUS DP to control Siemens MicroMaster 440
My tutor asked me for this small project: using S7-200 control MM440 with PROFIBUS. Because S7-200 with PROFIBUS module EM277 can only be PROFIBUS...
Replies
4
Views
2,973
Meihkkk
M
jtashaffer
Fault on a Micromaster 440 with Profibus adapter
I am getting a fault code F0022 (2) on the drive. Has anyone ran across this.
Replies
4
Views
4,194
Bering C Sparky
Bering C Sparky
Y
Micromaster 440 on Profibus
Hi All I have a project with a MM440 drive on profibus. What I would like to do is select it into two modes of operation via a selector switch...
Replies
3
Views
2,550
balash
B
K
Micromaster 440 on Profibus
Hi, I have an intresting problem: I replaced a mocromster vector drive with micromaster 440 which was running on profibus. I made the hardware...
Replies
3
Views
2,594
Jeff23spl
J
A
MICROMASTER 440 + profibus + encoder + limit switches
Hello all, We have a MM440 and 2 limit switches and one rotate encoder. And the MM440 is on profibus-dp. The encoder will tell the position so...
Replies
0
Views
2,264
AlecTek
A
Back
Top Bottom