Hello,
I'm working on project where I'm using an S7-1200 PLC, and I'm working with 3 devices that I'm connecting on a Profinet network.
I connect (on the TIA portal) each device and assign the IP address, and the TIA portal assigns the slot and the input/output addresses automatically, but when I connect the third device and asign the IP address the sofware doesn't assings the input/output addresses.
The devices are differents, and this happens with anyone of them (as long as it is the third one).
Because the system doesn't assigns the input/output addresses I can't compile the project nor download the hardware configuration.
Does anyone knows how can I correct this?
Best regards
Juan
I'm working on project where I'm using an S7-1200 PLC, and I'm working with 3 devices that I'm connecting on a Profinet network.
I connect (on the TIA portal) each device and assign the IP address, and the TIA portal assigns the slot and the input/output addresses automatically, but when I connect the third device and asign the IP address the sofware doesn't assings the input/output addresses.
The devices are differents, and this happens with anyone of them (as long as it is the third one).
Because the system doesn't assigns the input/output addresses I can't compile the project nor download the hardware configuration.
Does anyone knows how can I correct this?
Best regards
Juan