How do I do this?
_____O_____O_____
.....a.....b......
Motor "a" feeds material and b pulls it.
Can one program/wire the drives in such a way that b gets a setpoint and a follows but according to motor b's Current drawn.
Hope I'm clear on this. Basicly wot I'm trying is to control a's speed with the current drawn by b so that there is always tension between the two. Not a lot but just a little.
BTW the drives are Yaskawa Varispeed VS mini J7
tx.
_____O_____O_____
.....a.....b......
Motor "a" feeds material and b pulls it.
Can one program/wire the drives in such a way that b gets a setpoint and a follows but according to motor b's Current drawn.
Hope I'm clear on this. Basicly wot I'm trying is to control a's speed with the current drawn by b so that there is always tension between the two. Not a lot but just a little.
BTW the drives are Yaskawa Varispeed VS mini J7
tx.
Last edited: