JeremyM
Lifetime Supporting Member
Hi all,
I've been without luck flashing a 5069-HSC2xOB4/A module to anything higher than the onboard v1.050 firmware.
Has anyone else had luck with this module, or others in general?
The setup:
Approaches and tools tried:
Furthest degree of success:
I've been without luck flashing a 5069-HSC2xOB4/A module to anything higher than the onboard v1.050 firmware.
Has anyone else had luck with this module, or others in general?
The setup:
- Controller is a L320ERM with firmware 32.14
- Module is working, has firmware 1.050, and occupies slot 1
- No other modules
- MOD power good
- SA power good
Approaches and tools tried:
- Direct Ethernet and USB connections
- Controller in remote run or program mode
- Module inhibited in I/O tree
- Module not inhibited in I/O tree
- Module removed from I/O tree
- Module inhibited in I/O tree and manually reset
- 2.011 / 3.012 with latest ControlFlash
- 2.011 / 3.012 with latest ControlFlash Plus
- RSLinx Classic Gateway
- FactoryTalk Linx
- 2 hours of phone support with Rockwell (this included all of the above including a factory reset of the controller)
Furthest degree of success:
- ControlFlash claims the module isn't in the correct mode to accept a firmware update, fails, then provides a pop-up "Manually Reset Module"
- ControlFlash Plus immediately advances from 'Flashing' to 'Polling for Power-Up', then times out with error "Failed to begin update to the target device.The target device is not in the proper mode to accept an update.Manually Reset module"
Last edited: