kevinkevin
Member
Dear all,
This is my first time using Siemens TIA1500 system. I am facing some difficulty setting up my analog module 6ES7 531-7NF10-0AB0 to work.
I am using this 2 wire wiring diagram as per manual as attached. And in my program hardware I have already set to 2 wire configuration 4-20mA. No matter how I simulate my signal, it refuses to change from -32767 value. I have tested my signal injector, and I have also tried the 4 wire configuration and wiring, but still not working.
Please help if I am missing out some crucial settings, thanks!
This is my first time using Siemens TIA1500 system. I am facing some difficulty setting up my analog module 6ES7 531-7NF10-0AB0 to work.
I am using this 2 wire wiring diagram as per manual as attached. And in my program hardware I have already set to 2 wire configuration 4-20mA. No matter how I simulate my signal, it refuses to change from -32767 value. I have tested my signal injector, and I have also tried the 4 wire configuration and wiring, but still not working.
Please help if I am missing out some crucial settings, thanks!