Control Issues
Member
Just built a new panel with micrologix 1000 and PV300 micro in the old garage tonight. Tested out the programs by connecting a 1761-CBL-HM02 cable between the two. As always, found an error and had to reconnect up the DF1 cable to the Micrologix 1000.
My issues...the 1761-CBL-HM02 cable male connector will not release from the female Micrologix 1000 connector.
The new 1761-CBL-HM02 cable has what appears to be a latching plastic slider over the connector and I assume a feature to provide a positive locking connection of some sort.
Can't seem to get it to release. I don't want to damage the PLC considering it's shipping tomorrow. Before I apply a screw driver for leverage...and advice?
Completely not a problem I was expecting tonight. I have used this combo many times in the past but it's been a couple of years.
Thanks is advance for any response.
My issues...the 1761-CBL-HM02 cable male connector will not release from the female Micrologix 1000 connector.
The new 1761-CBL-HM02 cable has what appears to be a latching plastic slider over the connector and I assume a feature to provide a positive locking connection of some sort.
Can't seem to get it to release. I don't want to damage the PLC considering it's shipping tomorrow. Before I apply a screw driver for leverage...and advice?
Completely not a problem I was expecting tonight. I have used this combo many times in the past but it's been a couple of years.
Thanks is advance for any response.
Last edited: