Hello,
I need to configure two midimaster drive and set up most of paramteres to be exactly the same as paramters of a third drive that is currently in operation. One way is to manually go through all parameters by using operator board. Other much faster way would be to upload all parameters with some software and download same configuration to other drives.
Now I have got Siemens STARTER software that can be used to configure Micromaster drives. My biggest problem now is what cable to use it to connect PC (notebook) to midimaster drive?
Should it be simple NULL modem cable?
Do you have some experience with this issue?
Thanks
I need to configure two midimaster drive and set up most of paramteres to be exactly the same as paramters of a third drive that is currently in operation. One way is to manually go through all parameters by using operator board. Other much faster way would be to upload all parameters with some software and download same configuration to other drives.
Now I have got Siemens STARTER software that can be used to configure Micromaster drives. My biggest problem now is what cable to use it to connect PC (notebook) to midimaster drive?
Should it be simple NULL modem cable?
Do you have some experience with this issue?
Thanks