Hossam Azzaz
Member
Dear All,
I'm new to programming Schneider PLCs. I've:
CPU: TM200CE40R
DI Module: TM3DI16
DO Module: TM3DQ16R
AIO Module: TM3AM6
Everything was going OK in office (i.e. no HW configuration errors, or no programming errors), but in site, after downloading the ladder user program I found error message of CPU is not consistent with other Modules which are colored in red.
I can't find where exactly the error cause. I need to know.
Thanks.
I'm new to programming Schneider PLCs. I've:
CPU: TM200CE40R
DI Module: TM3DI16
DO Module: TM3DQ16R
AIO Module: TM3AM6
Everything was going OK in office (i.e. no HW configuration errors, or no programming errors), but in site, after downloading the ladder user program I found error message of CPU is not consistent with other Modules which are colored in red.
I can't find where exactly the error cause. I need to know.
Thanks.