I am trying to upload a program off of a panelview micro 300.... without much luck.
I am using a 1747 UIC, which I believe is necessary because from what I can tell, the unit is setup for DH485. The PLC(micrologix 1200) is setup to use DH485, baud 19,200, and node address 1. The panel communicates to the PLC, so I know the comm port is working.
I installed panelbuilder32 and when I try to upload using the UIC driver, It quickly throws the following errors:
error 2258 unable to communicate with operator terminal, did not receive a response
error 2258 verify your cable connections
info 2258 if you are using a direct connection to a panelview via df1, insure that the panelview does not have its printer port enabled.
I am kind of stuck here and was hoping that maybe someone could shed some light that has more experience with these.
I am using a 1747 UIC, which I believe is necessary because from what I can tell, the unit is setup for DH485. The PLC(micrologix 1200) is setup to use DH485, baud 19,200, and node address 1. The panel communicates to the PLC, so I know the comm port is working.
I installed panelbuilder32 and when I try to upload using the UIC driver, It quickly throws the following errors:
error 2258 unable to communicate with operator terminal, did not receive a response
error 2258 verify your cable connections
info 2258 if you are using a direct connection to a panelview via df1, insure that the panelview does not have its printer port enabled.
I am kind of stuck here and was hoping that maybe someone could shed some light that has more experience with these.