mhammer214
Member
I have a system where I replaced a SLC5/04 with a CompactLogix 5370 1769-L30ER. There is also a PanelView Plus 600 2711P-T6C8D Ser C that was connected to the SLC through a 2711P-RN8 DH+ communication module. I now have the PanelView and CompactLogix connected through ethernet.
I changed the shortcut to the L30ER processor and linked to the new ACD file as the offline tag database and assigned the shortcut to the processor.
After creating a runtime as version 5.1 I get this in the validation results:
"WARNING: Unsupported device detected. Shortcut name = "Main". Device name = "WO_ROY". Description: The system has detected that a device that is not supported in the requested version is referenced by a shortcut. This situation may not cause any runtime error if the system, upon which this project is to be run, has received a patch or has been upgraded to a newer version that support for this device. Otherwise runtime errors will be detected and logged in the target system when the system attempts to communicate to that device. "
It seems that the L30ER is too new to be supported in the PanelView 5.1 firmware.
Is there any way I can make this work without replacing the PanelView?
I have FTView Studio 8.20 installed.
Thanks in advance
I changed the shortcut to the L30ER processor and linked to the new ACD file as the offline tag database and assigned the shortcut to the processor.
After creating a runtime as version 5.1 I get this in the validation results:
"WARNING: Unsupported device detected. Shortcut name = "Main". Device name = "WO_ROY". Description: The system has detected that a device that is not supported in the requested version is referenced by a shortcut. This situation may not cause any runtime error if the system, upon which this project is to be run, has received a patch or has been upgraded to a newer version that support for this device. Otherwise runtime errors will be detected and logged in the target system when the system attempts to communicate to that device. "
It seems that the L30ER is too new to be supported in the PanelView 5.1 firmware.
Is there any way I can make this work without replacing the PanelView?
I have FTView Studio 8.20 installed.
Thanks in advance